Fortinet MR1 - Page 298

298
<bw> - Valid range is (0 to 100) in increments 5.
no - This command restores the default shaping rate value.
Default Setting
None
Command Mode
Interface Config.
This command specifies the maximum transmission bandwidth limit for all interfaces. Also
known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so
that the transmitted traffic rate is bounded.
Syntax
queue cos-queue traffic-shape all <bw>
no queue cos-queue traffic-shape all
<bw> - Valid range is (0 to 100) in increments 5.
no - This command restores the default shaping rate value for all interfaces.
Default Setting
None
Command Mode
Global Config.