Fortinet MR1 - Page 431

431
Configuring Outbound Telnet Client Configuration Page
Configurable Data
Admin Mode - Specifies if the Outbound Telnet service is Enabled or Disabled. Default value is
Enabled.
Maximum Sessions - Specifies the maximum number of Outbound Telnet Sessions allowed. Default
value is 5. Valid Range is (0 to 5).
Session Timeout - Specifies the Outbound Telnet login inactivity timeout. Default value is 5. Valid
Range is (1 to 160).
Command Buttons
Submit - Sends the updated configuration to the switch. Configuration changes take effect
immediately.
Configuring Serial Port Page
Configurable Data
Serial Port Login Timeout (minutes) - Specify how many minutes of inactivity should occur on a serial
port connection before the switch closes the connection. Enter a number between 0 and 160: the factory
default is 5. Entering 0 disables the timeout.