Fortinet MR1 - Page 441

441
Configuring Command Logger Page
Configurable Data
Admin Mode - Enable/Disable the operation of the CLI Command logging by selecting the
corresponding pulldown field and clicking Submit.
Command Buttons
Submit - Update the switch with the values you entered.
Configuring Console Log Page
This allows logging to any serial device attached to the host.
Configurable Data
Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log
messages. Enable or Disable logging by selecting the corresponding line on the pulldown entry field.
Severity Filter - A log records messages equal to or above a configured severity threshold. Select the
severity option by selecting the corresponding line on the pulldown entry field. These severity levels
have been enumerated below:
-Emergency (0): system is unusable
-Alert (1): action must be taken immediately
-Critical (2): critical conditions
-Error (3): error conditions
-Warning (4): warning conditions
-Notice(5): normal but significant conditions
-Informational(6): informational messages
-Debug(7): debug-level messages
Command Buttons
Submit - Update the switch with the values you entered.