Fortinet MR1 - Page 489

489
1.5*LeaveAllTime. Permissible values are 200 to 6000 centiseconds (2 to 60 seconds). The factory
default is 1000 centiseconds (10 seconds).
Configuring the whole Switch GARP Configuration Page
Note: It can take up to 10 seconds for GARP configuration changes to take effect.
Configurable Data
GVRP Mode - Choose the GARP VLAN Registration Protocol administrative mode for the switch by
selecting enable or disable from the pull down menu. The factory default is disabled.
GMRP Mode - Choose the GARP Multicast Registration Protocol administrative mode for the switch by
selecting enable or disable from the pull down menu. The factory default is disabled.
Command Buttons
Submit - Update the switch with the values you entered. If you want the switch to retain the new values
across a power cycle you must perform a save.