598
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect immediately.
These changes will not be retained across a power cycle unless a save is performed.
Delete - Remove the currently selected Rule from the selected ACL. These changes will not be
retained across a power cycle unless a save configuration is performed.
Configuring Access Control List Interface Configuration Page
Configurable Data
Slot/Port - Specifies list of all available valid interfaces for ACL mapping. All non-routing physical
interfaces and interfaces participating in LAGs are listed.
Direction - Specifies the packet filtering direction for ACL.
Valid Directions
Inbound
ACL Type - Specifies the type of ACL.
Valid ACL Types
IP ACL
MAC ACL
IP ACL - Specifies list of all IP ACLs. This field is visible only if the user has selected "IP ACL" as "ACL
Type".
MAC ACL - Specifies list of all MAC ACLs. This field is visible only if the user has selected "MAC ACL"
as "ACL Type".
Sequence Number - An optional sequence number may be specified to indicate the order of this
access list relative to other access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface and
direction, the specified access list replaces the currently attached access list using that sequence
To Next Page
Loading...
