Fostex DMT-8VL - Page 100

DMT-8VL Owner's Manual (Edit function)
Entering and storing the CLIPBOARD OUT point
4 Pres* the RECALL key, then the CLIPBOARD OUT key (or press only the
CLIPBOARD OUT key), and the unit enters edit mode.
5 Move the cursor to the digit you wish to change the HOLD/> key or the SHUTTLE
dial, and change the value using the JOG dial.
6 After setting the value, press the STORE key. then the CUPBOARD OUT key.
The time value nil? be stored as the Clipboard Out time, cdtt mode *111 disengage, and the
display will return to the previous screen.
r To check the stored IrvOut points, press the CUPBOARD IN key and CLIPBOARD
OUT key rospocbvoty The time value you |uert stored wil be shown on the deploy
• You can perform steps 1-3 in roaMrmo (Pressing the STORE key. then the
CLIPBOARD IN key wtuis playing beck Ihe recorder we store data.)
Hints:
When you are storing the IrYOut ports in real-time *hie usmg the •BAR.'BEAT/CIK*
Time Base, you can store them in stops of beats * the “rESoLu* (Display Resolution
mod© OWOFF) in Setup mode «*ON. #
When the resolution mode is "ON.* the CLK value will be rounded up or off to "CK7 (at
the beginning of the beat) as soon as you press the STORE key. This function as
useful when you wish to use the Copy & Paste or Move & Paste function is steps of
beats Refer to page “132" tor detailed operation
__
Moving the track data after storing the CLIPBOARD IN/OUT points
7. Select Ihe move track using the RECORD TRACK salect keys (you can select
multiple tracks).
• You can select a mono track or multiple tracks.
When using the Copy & Paste or Move & Paste function, however, you can change
the paste destination track only when you have se'ected a mono track, or an odd-
nunbared track and the adjacent even-numbered track (i.a.; 1-2. 3-4. 5-6. or 7-8).
H you have moved multiple tracks (other than the above combination), the data will
, be pasted to the move source tracks, (track 1«* track 1.track 3-> track 3 ate.)
8 Press the MOVE key.
Move is immediately completed.
The display n111 show *Move Qtp m and m COMPLETED! m and return to the previous screen.
Now the sound data In the specified track has been moved to the Clipboard.
At this point, the move source data has yet been deleted. It will be deleted
after you perform the paste operation.
100