Fostex DMT-8VL - Setting the MTC Frame Rate (FRAME RATE)

DMT-8VL Owner's Manual (SETUP mode)
9. Setting the MTC Frame Rate (“FRAME RATE“)
'FRAME RATE” in Setup mode allows you to set the MTC frame rate when you
select "MTC” for the ”MIDI SYNC OUT’ parameter to output MIDI timecode to an
external computer. You can select 2SF, 24F, 30DF. or 30ND for a frame rate.
This setting is available for each Program, and will he maintained after the power
is turned ofT.
1. Press the STORE key while pressing and holding down the HOLD/> key to select
s Program.
2. Press the DtSP SEL key to select "SETUP" and press the EXECUTE/YES key.
(•SETUP - will light up.)
Turn the JOG dill to select "FRAME RATE* (Winking), and the display will change as
shown below and will display the default setting. (The default setting is "2SP .")
3.
Press the EXECUTE/YES key again.
T on the display will blink, indjcaling that you can edit the parameter.
4. S elect a desirable option using the JOG dial.
5. After you select e frame rate, press the EXECUTE/YES key again.
The display will return to that displayed in step 2. and the setting will be complete.
6. Press the STOP button or ths EXIT/NO key to quit Setup mode.
• See pages "67* and 'S9 0 for more information on uwng s DMT-0VI connected to s MIDI
sequencer or computer.
126