Fostex DMT-8VL - Setting MTC Offset Time (MTC OFFSET)

DMT-Svl Owner's Manual (SETUP mode)
10. Setting MTC Offset Time ("MTC OFFSET")
"MTC OFFSET* In Setup mode allows you to create a time offset from ARS time
when you select "MTC* for the ’MIDI SYNC OUT’ parameter to output MIDI (imecode
to an external computer. You can specify any time within a range of
(VOODOO,:00 f :00 w • 5 K :59 M :59,:29,:99 a .
This setting is available for each Program, and will be maintained after the power
is turned off.
1. Press the STORE key while pressing and holding down the HOLfV> key to select
a Program.
2. Press the D1SP SEl key to select "SETUP* and press the EXECUTE/YES key.
(•SETUP* will light up.)
Turn the JOG dial to select "MTC OFFSET (blinking). and the display will change as shewn
below and will display the default setting, (The default setting is "0:59:57.-00:00.")
3. Press the EXECUTE/YES key agein.
"S" on the display will blink. Indicating that you can edit the parameter
Use the HOW/> key or the SHUTTLE dial to select the digit you wish to edit (hour, minute.
second, frame, sub-frame), and use the JOG dial to set or change the value.
4 . After setting the value, press the EXECUTE/YES key again.
The display will return to that displayed In Hep 2. and the setting will be complete.
5. Press the STOP button or the EXIT/NO key to quit Setup mode.
127