Fostex DMT-8VL - Setting Display Resolution Mode On;Off (Resolu;)

DMT-8VL Owner's Manual (SETUP mode)
14. Setting Display Resolution mode On/Off (“rESoLuJ”)
"rESoLu J" In Setup menu allows you to turn Display Resolution mode on and off.
When you are storing the ln/Out points in real-time while using the "BAR/BEAT/
CLK" Time Base, you can store them in steps of beats if the "rESoLuJ" (Display
Resolution mode On/Off) in Setup mode is *ON".
When this resolution mode is •ON”, the CLK value will be rounded up or off to "00"
(at the beginning of the beat) as soon as you press the STORE key. This function
is useful when you wish to use the Copy & Paste or Most & Paste function in steps
of beats.
This setting will be shared by all Programs and maintained after you turn off the
power,
• For example, i you try to store value *001“". •I** 1 *, as the copy start poirrf,
and '0V2~*\ as the end pent while using the BAR/8 EAT/CLK Time
Baee. these values will be stored as follows when they are held If Deplay Resolution
mode has been set to on:
The folowing example uses a time signature of 4/4.
-0011**-. “48 C1 *" -> "001**", "I*®"*. "GO"’ (CLK value % cut off)
•002**", •51 flul *->*003^*, •1 BB "\ *00 aJC *(CLK value e rounded up )
1. Press the DISP SEL key to select "SETUP* and press the EXECUTE/YES key.
(•SETUP' will light up.)
Turn the JOG d/a/ to select Winking "rBSoLu T he display nil! change to something
similar to this, and the current va tue will appear. (The default setting Is "oFF' J
2 Press the EXECUTE/YES key again.
Letters "oFF" on the display will Ntnk. and you can now edit the value
3. Use the JOG dial to select "oFF" or "on".
Turning the JOG dial counter<lockwlse will select ’oFF\ and turning It clockwise will
select *on".
4. Press the EXECUTE/YES key again.
The display in Step 1 will appear, and the setVng is complete.
5. Press the STOP button or the EXIT/NO key to quit Setup mode.
132