Fostex DMT-8VL - Effect Connection

DMT-8VL Owner's Manual (Before operating the DMT-8 vl)
7. Effect Connection
The DMT-ftVL is equipped with two sets of AUX send (mono-out) and AUX return
(stereo-in), allowing two effect units with mooo-in/stereivout to be connected. (Sec
the figure below.)
<Sign*l fVow>
Th* comKtad affact unit rocanas agnoJ mat ts roulad to the DMT-*t'a INPUT tartan
A*aho*oin ttia dtogram below. uaa ma INPUT SEL wrtfch to sotoct the signal inpt* to toa WPUT tack or the
signal output Irom ttia recccder to root# « to toa INPUT Mar.
TWt signal Is adjusted lof m# tovel via ma INPUT tedar. t*n processed by ma aqualiar. rtxnad to AUX SEND
1 or AUX SEND 2 (depeodog co too saffing of too AUX sand knot)) and sant to too oonnoctod eflsct urtl
Fot aaampia. t you wish to apply **act to toa sgnt input at the INPUT jack. sat m* INPUT SEL switch to
TNPUT*
If you vash to apply an **td to ma racordar o^*ut »qnaJ (playback agr*). ** INPUT SEL awAch to
'TRK.* Tha sgrwl a output from tf* affect unit and nrturrad to tha AUX RTN fade of too OMT-*«t. then lava*-
ocjusled ^a the AUX RTN knob, and InaPy sent to me reootoaf taction (or m# STEREO OUT UW jades) and
tha monitor aeedon