Fostex DMT-8VL - Page 40

DMT-8VL Owner's Manual (Before operating the DMT-8VL)
<Hlnt>
The previous section “Effect Connection" explained how to connect a mono-
In/stereo-out effect unit. If you wish to connect a stereo-ln/stereo-out effect
unit, refer to the following diagram:
Effect Un*
S€Mji AUX SCNO 9
0 ©] |g>;io' i
TgT ©’ 0 :l O’- o’ <
OjjD ■ O- ©• O O- »
I A. A A A ijST A !
A- A- A- .0- Ar A- j
«y ©' j
m KJ BH BS| m m b
■ j d illL ■
B e B B§ 9 f
As shown in this diagram, conned the DMT-8vi*s AUX SEND 1 and 2 to the INPUT UK
jacks of the effect untL For example. If you wish to Input a stereo sound source at INPUT
jacks 1 and 2 and apply an effect to this stereo signal, turn Channel I AUX send knob to
“Al.“ and turn Channel 2 AUX send knob to *A2“ to route the signal to the effect unit.
40