Fostex DMT-8VL - Page 107

DMT 8vl Owner's Manual (Edit function)
3 After setting the time value, press the STORE key. then press the AUTO PUNCH
IN key.
The time vihie will be stored is i start point of the cut area, and the display will return to
the previous screen.
y To check the cut In pent, press the AUTO PUNCH IN key The <*splay wM show the
| stored time value
Executing the cut operation
4 Press all RECORO TRACK select keys (to ready aV tracks)
5 Press the ERASE key.
The upper row of the 7-segment display will show "Cut. 0 and message "SURE?" will blink.
6 Press the EXECUTE/YES key.
Mta the operation is complete, the display shows the message "COMPLETED !," then
returns to the prex'ious screen,
f’ n this way. sound data starting from a specified postton is out and an unwritten area j
will be left on the herd disk.
Undo/Redo the Cut operation
If you wish to restore data that exsted be4ore you executed the Cut fixicbon, press the
UNDO key to restore the State of the 0MT-8vt prior to the cut. Pressing the REDO key
after you press tie UNOO key will restore the status poor to the Undo operation. The
Undo and Redo tun ebons are effective only while the DMT-dvt is slopped After the
UNOO key or REDO key e pressed, the display w.l show “COMPLETEDI• and return to
the previous screen.
<Note>
You can use the undo*redo functions while the DMT-8v\ is n slop mode
Under the following cwcumstance*. you will be unable to use the undo.'redo functions
1. If you make a rew recording,
2. if you make a new edit (Copy & Paste, Move A Paste. Erase, or Cut).
3 if the Auto Punch in pomt was passed n play or record mode while Auto Punch
mode was on. or
4 I you fumed C*1 the power to »ie DMT ^vt. then turned it back on
<Note>
tt you try to cut the data lor a Program in its ertroTy by storing the ABS 0 pant at the AiAo
Piaich In point, abotx 100ms of data may remain at the begnnng
| In Xus case use the ERASE function to erase the unnecessary part (The Erase function
can erase data that was not deleted by the Cut funebon)
107