Fostex DMT-8VL - Page 11

DS1T-8vl Owner's Manual (Main features ofDMTSvi)
Internal programmable Tempo Map
* The DMT-8 vl is equipped with an Internal programmable Tempo Map
that allows the MIDI clock and Song Position Pointer to be transmitted
to an external sequencer iswitchablc to MTC output) for complete
synchronization with a hardware sequencer. You can also use Track 8
as a Metronome playback track, which will generate counts according
to a Tempo Map. (Refer to pages ’113' - "116" for more details.)
* Eleven types of Tempo Map signature are available: 1 /4, 2/4, 3/4,4/4,
5/4, 1/8, 3/8, 5/8, 6/8, 7/8, and 8/8. Maximum 64 points of signature
can be set.
* Up to 64 points of tempo on a Tempo Map can be set on any point
determined by the signature settings, in the range of 30 - 250 per quarter
note. (Refer to page "114* for more details.)
Setup Menu function
* The DMT-8VL is equipped with the following setup Menu functions for
the interactive operation system. You can use a highly visible FL tube
display and the jog/shultle dial to set the parameters. (Refer to page
"108" for more details.)
Mein Setup Menu
LOAD (loading audio and setup data) (Refer to page "fir for details.)
SA VE (saving audio and setup data) (Refer to page ’117" lor details )
FORMA T (formatting the internal hard dtskj (Refer to page ’123'for details.)
PREROLL (setting the Pre-roll time) (Refer to page ‘124‘for details.)
MIDI SYNC OUT (selecting UTC. MIDI clock, or OFF) (Refer to page '125' for details )
FRAME RATE (setting the MTC frame rate) (Refer to page • 126' for details.)
MTC OFFSET (setting the MTC offset value against the A0S time) (Refer to page '127~ lor
dated*)
BAR/BEAT SET (setting the signature) (Refer to page '113' for details.)
TEMPO SET (setting the tempo) (Refer to page '114' for details )
CLICK ON/OFF (switching the Metronome function ON/OFF) (Refer to page '118'for
details.)
REC ENABLE (setting the RFC ENABLE or RFC DISABLE) (Refer to page '128' for defats.)
dO fn (selecting a digital input channel) (Refer to page ' 129' for details )
dO out (selecting a mg W output channel) (Refer to page '131'for details.)
rESoLu (setting Display Resolution mode ON/OFF) (Refer to page '132' for details )
SLAvE (sotting Slave mode ON/OFF) (Refer to page '13T for dotard.)
dEvIcE (setting a demco 10) (Refer to page '134' for details.)
undo (setting an affective range of the Undo function) (Refer to page '135' for details )
Easy-to-use jog/shuttle dial
* Using the shuttle dial allows for +/-1, 2, 3, 5, 9, 12. or 20 time speed
cueing (fast-forward while monitoring audio).
* Using the jog dial allows for digital audio scrubbing. Using this function,
you can locate data efficiently while monitoring audio without any
changes in pitch.
* The jog/shuttle dial is also used to recall parameters and to enter data.
11