Fostex DMT-8VL - Page 49

DMT 8VL Owner's Manual (Recording/Playback)
Signal flaw during basic recording
The diagram shown below shows the flow of recording signal and monitoring signal.
Remember the route of the Input signal sent and recorded to the hard disk and the
monitoring signal sent to the monitor section. Also, find out which knob or switch
is used to select one of the signals sent simultaneously.
<Nda» on recordlng>
As oxplanod n toe MC0On “Before Openttog no DOT8w.* uong the miser tonetton e*>*s you to re asm 1he channel
signal to r>o stereo toe l irdtor R ueng toe PAN knot), toon -oute ft to toe coreepoodtog treats) ft racks 1 (W7 from
too sieroo tea L. and Tracks ?A4M horn toe stareo bus R) for recording Therefore, you cerrc* record each (afferent
*xr>d octree inpul from INPl/T facts 1-8 into Tracks 1-8 respective* end stovitaneoua*. but sound sources writ
cr.xarws each other to Tracks 1-8 acccrdng to toe PAN «noP setonge
Ci £f o (57i fi 6 fi boo fi~o fi no 5 fl o ffo o o 6
t t t t t f 1M111 t 1 t t
When Ttacks 1-8 are selected lor recort*ng (that a. all me RECORD TRACK select
keys aro ON), me channel signals *v» be routed to multiple tracks eccorckng to the
PAN knob seRngs, n» Jbng in overlapping aoimd at a beck
49