Fostex DMT-8VL - Page 95

DMT-8VL Owner's Manual (Edit function)
3 After setting the value, press the STORE key. then the CUPBOARD IN key.
The lime valuer nt II be stored os the Clipboard In time, edit mode will disengage, And the
display n ill return to the previous screen.
Entering and storing the CLIPBOARD 0~UT~poifrt ~
4 Press the RECALL key, then the CLIPBOARD OUT key (or press only the
CUPBOARD OUT key), end the unit enters edit mode.
5. Move the cursor to the digit you wish to change using the HOLEV> key or the
SHUTTLE dial, and change the value using the JOG dial.
6 After setting the value, press the STORE key. then the CUPBOARD OUT key.
The time value will be stored as the Clipboard Out rime, edit mode will disengage, and the
display will return to the previous screen.
• To check the stored IrVOut point*, press the Ct^BOARO IN key and CLIPBOARD
OUT key respectively The time value you just stored wa be shown on the display
( * You can perform step* 1-3 in readme (Pressing the STORE key then the
CLIPBOARD IN key while playing back the recorder w« store data.)
r
Hints:
When you are stomg the evOut pomts n real-time while using the “BAR/BEAT/CLK"
True Base, you can store them in steps of beats If me ‘rCSoLu" (Display ResokJtion
mode OWOFF) in Setup mode is ‘ON *
When Ihi* resolution mode s “ON.‘ the CLK value wd be rounded up or off to ‘00“
(at the beginning of the beat) as soon as you preas the STORE key The function la
usefii when you wish lo use the Copy & Paste or Move & Paste function In setLps of
beats Refer to page *132* lor detailed operation
Copying th« track data aftar storing tha CUPBOARD IN/OUT points
7. SHect th« copy track uaing the RECORO TRACK aetoct keya (you can select
mult>p*e tracks).
• You can select a mono track or mutttpfe tracks
When using the Copy & Paste function, however, you can change me paste
destination track ony when you have selected a mono track, or an odd-numbered
track and the adecent even-track (la.: 1-2,3-4, 5-6. or 7-6}
ft you have copied mu*pie tracks (other than the above combination), the data will
bo pasted to the copy source tracks (track 1-> track 1_track 3-> track 3 etc.)
8 Press the COPY key.
Copy is Immediately completed The display will show XOMPLETEDT and return to the
previous screen.
In this way, the specified part of the sound data of the selected track(s) is
copied to the clipboard.
95