SECTION 4 - MECHANICAL OVERHAUL
29
F32 SERIES
Pri nt P2D32F005 E Base - April 2009
119572
119567
Figure 63
CYLINDER HEAD ASSEMBLY
Lubricate the valve stems (1) an d fit t hem in the relevant
valve guides in the same position they were before
disassembly.
Fit the grommets (2 and 3) to the valve gu ide using tool
99360292.
Place the spring (4) and the upper plate (3) on the cylinder
head. Using tool 99360268 (1), compress the spring (4) and
constrain the parts to the valve (5) throughout the half cones
(2).
Figure 64
Check that the cylinder head and crankshaft coupling
surfaces are c lean.
Do n ot fou l the cylinder head gasket.
Fit the gasket (1) on the crankshaft in the correct centred
position, taking the pins as reference (2).
119573
Figure 65
Cylinder head reassembly
To Next Page
Loading...
