Figure 5
ENGINE LUBRICATION SYSTEM
Forced circulation lubrication is controlled by the rotor oil
pump housed in the front part of the engine basement and
driven by the toothed gear splined on the shank of the engine
drive shaft.
From the oil pan, the lubrication oil is distributed to the engine
drive shaft, the camshaft and the valve control.
The lubrication system also comprises the heat exchanger, he
centrifugal blower for the versions with turbosupercharger
and eventually the compressor if the compressed air system
is also fitted.
All the above mentioned components vary depending on their
use and therefore will be illustrated in the specific section.
LUBRICATION SYSTEM DIAGRAM
1. Oil filter - 2. Oil pump - 3. Heat exchanging unit - 4. Heat exchanger -
5. Turbosupercharger lubrication feed pipe
127695
Pressurized oil
Dropping oil
6
SECTION 1 - GENERAL SPECIFICATIONS
F32 SERIES
Base - April 2009 Print P2D32F005 E
To Next Page
Loading...
