46
SECTION 3 - INDUSTRIAL APPLICATION
F32 SERIES
Base - April 2009 Print P2D32F005 E
Torque setting 8 ± 2 Nm
Engine drive shaft sensor (for F5CE5454 engines)
It is an inductive type sensor placed on the front left side of the engine.
It generates signals obtained by the magnetic flow lines closing up through the openings of a phonic wheel splined on the engine
drive shaft.
The same signal is used to pilot the electronic revolution counter eventually fitted on the vehicle instrument panel.
It is connected to the Electronic Control Unit pins 25C (signal) and 24C (signal). The third pin is for shielding. The Sensor’s resistance
value is nearly 900 .
119457
Pin 25 E.C.U.
Pin 23 E.C.U.
Pin 24 E.C.U.
Figure 98
To Next Page
Loading...
