Figure 26 Figure 27
Figure 28
Assemble the en gine drive shaft (2).
If it is not necessary to replace the cran kshaft
bearings, these shall be reassembled in th e same
order and position they were before disassembly.
Crankshaft bearing assembly
Do n ot t ry to adapt the bearings.
The spare crankshaft bearings (1) have undersize in ternal
diameter of 0.254 - 0.508 mm.
Carefully clean the crankshaft half bearings (1) having
lubrication port and fit them in t h eir respective seats.
The penultimate crankshaft half bearing (1) is provided with
shoulder half rin gs.
Crankshaft assembly
- carefully c lean the parts and eliminate any oil residuals;
- ffit the caps (1) and the half bearings (2) on the relevant
supports.
128169
119547
NOTE
NOTE
Always use new screws in phase of assembly.NOTE
125130
18
SECTION 4 - MECHANICAL OVERHAUL
F32 SERIES
Base - April 2009 Pri nt P2D32F005 E
To Next Page
Loading...
