Fronius IG Plus A 3.0-1 UNI User Manual

124
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
412
The "fixed voltage" setting has been selected instead of MPP voltage operation and the
voltage is set to too low a value, or DC voltage exceeds allowable limits.
Description Fixed voltage lower than the current MPP voltage.
Remedy If the status code persists, you should contact a Fronius-trained
service technician, or remove excess solar modules so DC volt-
age fits within inverter limits.
If status code persists: Contact a Fronius-trained service tech-
nician
413
Control problems
Description The inverter briefly disconnects from the grid, if AC voltage or
frequency are out of range.
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
414
EEPROM faulty
Description Memory deleted
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
416
Communication with IG Brain not possible.
Description The Operating Status LED lights up orange, then the inverter at-
tempts a restart.
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
417
Two power stage sets have the same PCB number
Description The inverter stops feeding power into the grid, the display
shows a critical error via a red Operating Status LED
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
419
Two or more power stage sets with an identical software serial number detected.
Description The inverter stops feeding power into the grid, the display
shows a critical error via a red Operating Status LED
Remedy If status code persists: Contact a Fronius-trained service tech-
nician

Fronius IG Plus A 3.0-1 UNI Specifications

General

AC nominal output	3000 W
Max. apparent AC power	3000 VA
Max. output current	13 A
AC grid frequency	50 / 60 Hz
THD	<3%
Max. DC voltage	500 V
Number of MPP trackers	1
AC voltage range	183 V - 264 V
DC input voltage range	150 - 450 V
Cooling	Convection