Save in: - Scan to FTP/SMB
109
1. Press the <All Services> button
on the control panel.
2. Select [Scan to FTP/SMB] on
the touch screen.
3. Perform the necessary
operations.
Transfer Protocol
Use this feature to select a transfer protocol. You must select the same protocol used
by the destination.
1. Select [Transfer Protocol] on the
[Scan to FTP/SMB] screen.
2. Select the required option.
3. Select [Save].
FTP
Specifies the FTP protocol.
SMB
Specifies the SMB protocol.
SMB (UNC Format)
Specifies the SMB protocol (using the UNC format).
NOTE: If Remote Authentication has been enabled a popup message will prompt the
user to enter a login and password before using the Scan to FTP/SMB feature. The
login and password will be passed to the Kerberos server. Only when the user is
authenticated (ex. User xyz is really user xyz), the feature will be made available.
Address Book
Use this feature to select a destination server from the Address Book. Selecting a
server causes the preset information to be entered into the entry fields: Server, Shared
Name, Save in, Login Name, and Password. For information on how to register
destinations, refer to Address Book in the Setups chapter on page 234.
1. Select [Address Book] on the
[Save in:] screen.
2. Perform the necessary
operations.
3. Select [Save].
Show Details
Displays detailed settings of the selected server.
To Next Page
Loading...
Need help?
General
