4 Fax/Internet Fax
94
NOTE: This feature is not displayed for iFax transmissions. However, you can use the
same feature by specifying an F Code directly in the iFax destination address.
1. Select [F Code] on the [Send
Options] screen.
2. Perform the necessary
operations.
3. Select [Save].
Off
Disables the feature.
On
Sets the F Code transmission. [F Code] and [Password] are displayed at the right side
of the screen.
• F Code – You can enter an F Code composed of spaces, numbers (0–9), and
symbols (#, *) up to 20 characters. Enter the code using the numeric keypad on the
control panel.
• Password – You can enter a password composed of spaces, numbers (0–9), and
symbols (#, *) up to 20 characters. Enter the code using the numeric keypad on the
control panel.
Next
Sets the entered value and moves to the other entry field.
iFax Profile
This feature allows you to specify a profile to restrict the attribute information for
transmissions between machines equipped with iFax, such as image resolution and
paper size.
NOTE: This feature is not available for regular fax transmissions.
1. Select [iFax Profile] on the
[Send Options] screen.
2. Select the required option.
3. Select [Save].
TIFF-S
This is the standard specification of iFax for documents that are larger than A4.
Automatically reduces the size to A4 for transmission.
• Data compression: MH
• Stored Document Size: A4
• Resolution: Standard, Fine
To Next Page
Loading...
Need help?
General
