Supported Paper Sizes and Types
175
Non-standard Sizes
Supported Paper Types
The following table lists the paper types supported for each paper tray, duplex module,
and the finisher.
O: Available
X: Not available
• Plain: Depending on the operating environment, certain types of plain paper may not
feed to the machine properly, or print quality may be negatively affected. Select
[Heavyweight 1] or [Heavyweight 2].
• Side 2 Paper: Refers to the paper already printed on one side (i.e., scrap paper).
• If you select [Label], [Heavyweight 1] or [Heavyweight 2], load the paper LEF. If
loading the paper SEF, printed quality may be negatively affected.
• Lightweight: If you select [Lightweight], the machine lowers the temperature of the
fuser unit when printing. Select this option when paper curls or other printing
problems occur due to high temperature in the fuser unit when it sets toner on the
paper.
• Heavyweight: Depending on the type of heavyweight paper, the machine cannot
load it SEF. In this case, set the paper LEF.
• Depending on the type of paper used and the operating environment, paper may not
feed to the machine properly, or print quality may be negatively affected.
Paper Size
Tray 1, 2/
Tray 3, 4
(Two Tray Module)
Tray 3, 4
(TTM)
Tray 5
(Bypass)
Duplex Module Finisher
Width 140 to 297 mm
Not Available
89 to 297 mm 89 to 297 mm
Not Available
Length 182 to 432 mm 99 to 432 mm 127 to 432 mm
(for Tray 5 (Bypass))
182 to 432 mm
(for Tray 1–4)
Paper Type
Weight (g/m
2
)
Tray 1
Tray 2, 3–4
(Two Tray
Module/TTM)
Tray 5
(Bypass)
Duplex
Module
Finisher
Plain
60–105
OOOOO
Recycled OOOOO
Side 2 Paper O O O X O
Transparency – O O O X X
Labels 60–105 O O O X X
Lightweight – O O O X X
Heavyweight 1 106–169 X O O X X
Heavyweight 2 170–216 X O O X X
To Next Page
Loading...
Need help?
General
