12 Setups
208
Other Settings
Use this feature to specify a printable area and replacement method when paper runs
short.
1. Select [Other Settings] on the
[Print Mode Settings] screen.
2. Use the scroll buttons to switch
between screens.
3. Perform the necessary
operations.
4. Select [Close].
Print Area
Sets the printable area to [Normal] or [Extended]. If you select [Normal], the printable
area excludes a margin 4.1 mm wide along all four edges of paper. If you select
[Extended], the printable area is extended to leave about 2 mm of margin along the
edges.
Substitute Tray
Sets the substitute tray when the machine cannot detect paper trays corresponding to
the document size with auto paper selection.
Display Message
Displays a message requesting paper supply without switching paper trays.
Use Larger Size
Switches to the tray loaded with the next larger size of paper and prints the document
in its original size.
Use Nearest Size
Switches to the tray loaded with the paper in the size closest to the selected paper.
Image size may be automatically reduced as required.
NOTE: The job sent from the PC takes priority over the job set on the machine.
Paper Type Mismatch
Sets whether to display or hide the confirmation screen when a paper type mismatch
occurs.
Unregistered Forms
Sets whether to abort a job which is specified to use form overlay when the form is not
found (not registered) in the machine.
Banner Sheet
Sets whether to add sorting sheets (banner sheets). This is effective for sorting/
classifying to differentiate printed sheets from the rest. You can add banner sheets
before and/or at the end of the print job.
NOTE: Even if using the Finisher, banner sheets will not be stapled.
To Next Page
Loading...
Need help?
General
