Fuji Xerox Document Centre 236 series User Manual

Print Mode Settings
207
Receiving Buffer - SMB Spool
Allows you to change the input buffer memory capacity for SMB interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 64–1,024 KB in 32 KB
increments using the scroll buttons.
Memory
Allows you to change the memory capacity within the range of 0.50–32.00 MB in 0.25
MB increments using the scroll buttons.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - IPP Spool
Allows you to change the input buffer memory capacity for IPP interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 64–1,024 KB in 32 KB
increments using the scroll buttons.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - Ethertalk
Allows you to change the input buffer memory capacity for Ethertalk interface within the
range of 1,024–2,048 KB in 32 KB increments using the scroll buttons. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Receiving Buffer - Port9100
Allows you to change the input buffer memory capacity for Port9100 interface within the
range of 64–1,024 KB in 32 KB increments using the scroll buttons. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”

Fuji Xerox Document Centre 236 series Specifications

General

Brand	Fuji Xerox
Model	Document Centre 236 series
Category	All in One Printer
Language	English