10 CentreWare Internet Services
158
Protocol Settings EtherTalk
Only displayed when PostScript is enabled.
Printer Name – Enter the printer name for EtherTalk.
Zone Name – Enter the EtherTalk zone name.
Printer Type – This is a display-only item.
SMB
Allows you to configure the SMB protocol settings as
following.
Workgroup – Enter the workgroup name.
Host Name – Enter the host name.
Maximum Sessions – Allows you to specify the maximum
number of sessions.
TBCP Filter – This is only displayed when PostScript is
enabled.
Unicode Support – Allows you to specify whether to enable
Unicode support in the host name and workgroup name
during SMB transmission.
Auto Master Mode – Allows you to enable or disable (on/off)
Auto Master Mode.
Encrypt Password – Allows you to enable or disable
password encryption during SMB transmission.
NetWare
Allows you to configure the settings for NDS, transport
protocol and SLP, as follows.
Host Name – Enter the host name.
Active Mode – Selects the Active Mode for the printer when
using NetWare.
• Directory: PServer Mode: Select this when using the
printer server mode in directory service.
• Bindery: PServer Mode: Select this when using the printer
server mode in bindery service.
File Server Name – Enter the file server name.
Polling Interval – Allows you to set the time interval from
when print data enter the print queue until printing starts.
Number of searches – Enter the maximum number of
searches.
Password – Enter the print server (PServer) password.
Re-enter Password – Allows you to verify the PServer
password by re-entering the same password.
TBCP Filter – This is only displayed when PostScript is
enabled.
NDS – Configure the NDS settings.
Tree Name – Enter the tree name.
Context Name – Enter the context name of the Print Server
Object. Up to 511 characters can be entered, with the
exception of + (plus sign), \ (backslash), and ~ (tilde).
Transport Protocol (IPX/SPX) – Configure the IPX/SPX
settings.
Feature Setting items
To Next Page
Loading...
Need help?
General
