11 Paper and Other Media
170
2. If required, move the paper tray
guides further out to load the
new stock.
To adjust the side and rear
guides, pinch the guide lever on
each guide and slide the guides to
their new position.
To secure the guides in position,
release the levers.
NOTE: The machine senses standard paper sizes. When loading custom-size paper,
make sure to specify the correct paper size in the machine. For information on
changing the size or type of stock in the tray, refer to Paper Tray Attributes in the
Setups chapter on page 182. For more information on reprogramming the tray, contact
the System Administrator.
3. Load the paper neatly and tightly
against the left-hand side of the
tray.
NOTE: Do not load paper above the
maximum fill line.
4. If the paper guides have been
moved, slide the guides to just
touch the edge of the paper.
NOTE: When loading standard size
paper, set the guides onto the
notches on the tray to match the
paper size. The machine recognizes
8K/16K paper as standard size even
though paper trays have no notches.
5. Close the paper tray.
Paper can be loaded either short edge feed or long edge feed.
6. Set the machine to detect the paper size automatically, or manually specify the
required size. For more information, refer to Paper Size in the Setups chapter on
page 183.
NOTE: Paper sizes detected by the machine vary depending on the System
Administrator setting. For more information, refer to Paper Size Settings in the Setups
chapter on page 188.
Long edge feed
(LEF)
Short edge feed
(SEF)
To Next Page
Loading...
Need help?
General
