Common Settings
181
Control Panel Select Tone
Select the volume level of the tone generated when an appropriate button on the
control panel is pressed and its action is accepted.
Control Panel Alert Tone
Select the volume level of the tone generated when an inappropriate button on the
control panel is pressed.
Machine Ready Tone
Select the volume level of the tone generated when the machine becomes ready to
copy or print, for example, after the power is switched on.
Copy Job Complete Tone
Select the volume level of the tone generated when copying finishes successfully.
Non-Copy Job Complete Tone
Select the volume level of the tone generated when a job other than copying finishes
successfully.
Fault Tone
Select the volume level of the tone generated when a job did not finish properly.
Alert Tone
Select the volume level of the tone generated when a job is suspended due to an error.
Out of Paper Warning Tone
Select the volume level of the tone generated when the machine runs out of paper.
Low Toner Alert Tone
Select the volume level of the tone generated when it is time to replace the toner
cartridge.
Line Monitor Volume
Select the volume level of the tone generated for the line monitor, which allows you to
hear call and response signals when connecting to a destination.
Ringing Volume
Select the volume level of the tone generated when a call is received.
Stored Programming Tone
Select the volume level of the tone generated each time operation is performed during
job memory registration. You cannot completely turn off the volume for this tone.
Auto Clear Alert Tone
Select the volume level of the tone generated just before the machine performs auto
clear.
To Next Page
Loading...
Need help?
General
