17 Problem Solving
320
The entire page
is printed faint.
When the print was made
using tray 5 (bypass tray),
the size and type of the
actually loaded paper
differed from the setting on
the print driver.
Either load paper of the correct size and
type into tray 5 (bypass tray), or fan the
paper thoroughly before loading it again.
Refer to Bypass Tray (Tray 5) on page 171.
Two or more sheets may be
feeding at once.
Fan the paper well and reset.
Refer to Loading Paper on page 169.
Paper becomes
wrinkled.
Text is blurred.
The paper in use is
unsuitable.
Replace with paper from a new ream.
Refer to Loading Paper on page 169.
Paper is being added while
it is being fed.
Is the paper damp?
White or color is
missing vertically
The drum cartridge is
depleted or damaged.
Replace with a new drum cartridge.
Refer to Replacing the Drum Cartridge on
page 285.
There is no toner left in the
toner cartridge.
Replace with a new toner cartridge.
Refer to Replacing the Toner Cartridge on
page 287.
A probable cause is a dirty
Raster Output Scanner.
Clean the Raster Output Scanner.
Text or images
are printed at an
angle
The paper guide in the
paper tray is not set at the
correct position.
Set the horizontal and vertical paper guides
to the correct positions.
Refer to Loading the Paper Trays on
page 169.
Symptoms Check Remedy
To Next Page
Loading...
Need help?
General
