18 Appendix
350
Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Active Coordinate
Area, Scaling: OFF
9. HP-GL/2 Emulation Mode Restriction
Using HP DJ750C, which is the emulation target for the HP-GL/2 emulation mode, sets
lines to a round joint if the lines are 0.35mm width or under. A miter joint is not set.
However, using the HP-GL/2 emulation mode of Document Centre 336/286/236 Series
always sets lines to a miter joint as a default regardless of the line width.
To cancel the default, use a command.
Print Area
Active Coordinate Area determined by
entered data
Paper Size
To Next Page
Loading...
Need help?
General
