13 Problem Solving
474
Problem Solving
13
116-742
[Cause] Logo data cannot be registered because you have reached the
maximum number of form registration.
[Remedy] Delete unnecessary forms.
116-743
[Cause] Form or logo data cannot be registered because of insufficient
memory for form / logo data.
[Remedy] Increase free space on memory.
116-746
Cause] The specified form is not registered.
[Remedy] Use a registered form or register a new form.
116-747
[Cause] The paper margin value is too large for the HP-GL/2 (optional)
active coordinates area.
[Remedy] Decrease the paper margin value, and then execute the
operation again.
116-748
[Cause] There is no plot data in the HP-GL/2 (optional) print data.
[Remedy] Check the print data.
116-749
[Cause] The job was cancelled because the specified font does not exist.
[Remedy] Install the font, or set the print driver to replace the font.
116-750
[Cause] Banner sheet tray malfunction
[Remedy] Restore the tray to normal condition or change the Banner sheet
tray.
116-751
[Cause] The process has been canceled because the hard disk is full.
[Remedy] Delete stored data in the hard disk. If the error still is not resolved,
split the file and send the job again.
116-752
[Cause] The descriptions of the PDF or XPS printing job ticket have a
problem.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
[Cause] The data was automatically modified because it included an
invalid parameter.
[Remedy] The printed image may be incomplete. Confirm with the sender
whether the image has a problem, or ask the sender to send the
data again. When using the Internet Fax Forwarding feature,
confirm its condition with the e-mail recipient.
116-780
[Cause] There is a problem with the document attached to the received e-
mail.
[Remedy] Check the attached document.
116-790
[Cause] Probable causes are as follows:
1) If the operator cancelled printing a document that was received
using the Store Fax - Local Folder or Store Internet Fax - Local
Folder feature:
The first set of the document is not stapled.
2) For causes other than 1)
No set of the document is stapled.
[Remedy] For 1), manually staple the first set of the document. Or, do not
cancel printing of a document that is received using the Store Fax
- Local Folder or Store Internet Fax - Local Folder feature.
For 2), check whether the staple position has been correctly
specified, and try printing again.
117-311
[Cause] Data Security Kit is not attached correctly.
[Remedy] Insert Data Security Kit into the correct slot.
Error Code Cause and Remedy
To Next Page
Loading...
Need help?
General
