Fuji Xerox DocuPrint CM505 da Administrator's Guide

Error Code
475
Problem Solving
13
117-312
[Cause] An error occurred in the machine.
[Remedy] Contact our Customer Support Center.
117-319
117-320
117-321
117-323
117-324
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
117-326
117-327
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
117-329
118-310
121-310
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
121-311
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Once IC Card Reader is connected to the machine, the machine
automatically changes the [Smart Card Link Mode] setting to
[Type Password] under [Tools] > [Authentication / Security
Settings] > [Authentication] > [User Details Setup]. Change the
setting as required.
121-312
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Switch on the machine power without connecting the device for
EP system, and then select [Login Type] to other than [Login to
Remote Accounts] under [Tools] > [Authentication / Security
Settings] > [Authentication].
121-313
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Switch on the machine power without connecting the device for
EP system, and then select [Login Type] to other than [Login to
Remote Accounts] under [Tools] > [Authentication / Security
Settings] > [Authentication].
121-314
121-316
121-317
121-318
121-319
121-320
121-321
121-322
121-323
121-324
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
121-333
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Confirm that the device is switched on, and then switch off
the machine power, make sure that the touch screen is
blank, and switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
Error Code Cause and Remedy

Fuji Xerox DocuPrint CM505 da Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM505 da
Category	All in One Printer
Language	English