(3) Click [Setup SNMP Interface] in [Action].
The [Setup SNMP Agent Basic Interface] screen appears.
(4) Select [Enable] for [SNMP Function], set the required items, and click the [Set] button.
Select the LAN port that was set up in Step 1 for "LAN Port used for SNMP".
A confirmation screen appears.
(5) Click the [OK] button.
The SNMP Agent basic settings are applied.
(6) Check the setting completion message and click the [Done] button.
The screen returns to the [Network] screen.
3 Set up the SNMP Manager.
Set up the SNMP Manager (monitoring server) that is the destination of the SNMP Trap transmission.
Note
This step is not required when ETERNUS SF Storage Cruiser is used to monitor the ETERNUS DX.
(1) Click [Setup SNMP Manager] in [Action].
The [Setup SNMP Manager] screen appears.
(2) In the manager list of the [Setup SNMP Manager] screen, click the [Add] button.
The [Manager] screen appears.
8. Monitoring Settings
Various Notification Settings
162 Configuration Guide (Basic)
To Next Page
Loading...
