EasyManuals Logo

Fujitsu Primergy TX120 User Manual

Fujitsu Primergy TX120
263 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
99
PRIMERGY TX120 User’s Guide
3
OS Installation Using ServerStart
3. Enter [Remote path], [User name], and [Password] and click [OK].
The [Initialization of ServerStart core running] window appears and the ServerStart
initialization process starts. Depending on the hardware configuration, this process may
take a few minutes. When the process is completed, the [Welcome to ServerStart] window
appears.
3 Click [Click here to prepare and/or initiate an operating system installation].
The [Select the operating system to be installed] window appears.
Click [Special Hints on Operating System Installation] and read the contents. Important
information such as limitations on disk configuration is described.
4 Click [MS Windows Operating Systems].
The [Install Microsoft Windows Operating System Installation] window appears.
5 Select the OS to install and the mode.
6 Set items in wizards and save the configuration file.
For settings in wizards, refer to "3.1 Guided Mode" (Jpg.52) or "3.3 Expert Mode" (Jpg.76).
Set items in wizards and save the configuration file. When using the remote floppy, specify the
path to the shared folder for the remote floppy as the configuration file saving location.
` Specify the shared name of the prepared shared folder instead of the local CD-ROM as instal-
lation source information.
7 Click [Click here, to Start the Installation of (OS)].
Installation starts. At steps where the CD-ROM for resources such as the OS to be installed is
necessary, the resource is automatically acquired from the resource server via the network.
8 Eject the CD-ROM and floppy disk and click [OK].
The system restarts. When the installation is completed, an installation completion message
appears on the target server.
9 Press any key on the target server.
10 Restart the system on the target server.
The server setup and OS installation have been completed.
Refer to "Chapter 5 Operations after OS Installation" (Jpg.123) and perform necessary procedures
before starting server operations.

Table of Contents

Other manuals for Fujitsu Primergy TX120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu Primergy TX120 and is the answer not in the manual?

Fujitsu Primergy TX120 Specifications

General IconGeneral
BrandFujitsu
ModelPrimergy TX120
CategoryServer
LanguageEnglish

Related product manuals