Field Description
The number of channels you can selected depends on the
country setting. Please consult the data sheet for your device.
Configuring the network name (SSID) in Access Point mode
means that wireless networks can be logically separated from
each other, but they can still physically interfere with each oth-
er if they are operating on the same or closely adjacent wire-
less channels. So if you are operating two or more radio net-
works close to each other, it is advisable to allocate the net-
works to different channels. Each of these should be spaced
at least four channels apart, as a network also partially occu-
pies the adjacent channels.
In the case of manual channel selection, please make sure
first that the clients actually support these channels.
• For Frequency Band = ;:F 2
Possible values are ', &, &&, & and " (default value)
• For Frequency Band = ;:F 218"
Only the " option is possible here.
Antenna Diversity Select how many and which antennas are used to send and re-
ceive.
If the function is deactivated, only the main antenna sends and
receives.
If the function is activated, two antennas receive and the better
signal is evaluated.
The function is activated with 7#,.
The function is activated by default.
Max. link range
Enter the maximum link range.
If the 6 " option is enabled, the automatically gen-
erated range is used.
If this option is not enabled, enter the desired maximum value in
the m field.
The 6 " option is enabled by default.
8 Wireless LAN Funkwerk Enterprise Communications GmbH
122 funkwerk W1002/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
