GE Security EST3 User Manual

Service and troubleshooting
EST3 Installation and Service Manual 8.33
Table 8-23: CRC pseudo points
Address Label Event type Description
SS35 CRC Relay Open Access output Activate the CRC relay
SS36 CRC Inside Reader Disable Access output Disable the inside card reader
device (for load shedding)
SS37 CRC Outside Reader Disable Access output Disable the outside card reader
device (for load shedding)
SS38 CRC Sounder Access trouble CRC sounder base trouble
SS represents the CRC device number, as configured in the SDU.
Table 8-24: KPDISP pseudo points
Address Label Event type Description
SS06 RAM Fault or Stack Fault Local trouble KPDISP processor failed
SS07 Code Supervision Local trouble KPDISP executable program
corrupt
SS08 Database Supervision Local trouble KPDISP database corrupt
SS09 Communications Fault Local trouble KPDISP lost communication with
3-SAC
SS12 Task Supervision Local trouble Changes to the active state
when a task fails to execute
properly
SS13 Waiting for Download Local trouble Database download from the
SDU is in progress or was
incomplete
SS14 User Record Supervision Local trouble N/A
SS15 Controller Communication
Fault
Local trouble KPDISP lost communication with
3-SAC (displayed on KPDISP
only)
SS16 Panel Communication Fault Local trouble KPDISP lost communication with
panel (displayed on KPDISP
only)
SS32 Entry Buzzer Nonsupervised
output
Activates for configured time to
allow the partition to be disarmed
before going into alarm
SS33 Exit Buzzer Nonsupervised
output
Activates for configured time to
allow the person arming a
partition to exit before signaling
any alarm events
SS represents the KPDISP device number, as configured in the SDU.

GE Security EST3 Specifications

General

Brand	GE Security
Model	EST3
Category	Security Sensors
Language	English