9-12 250cx Series Maternal/Fetal Monitor Revision C
2036946-001
Maternal Pulse Oximetry Monitoring: Module and Probe Compatibility
Modules and Sensors
The Masimo, Ohmeda, and Nellcor parameters are used to measure the amount of
oxygenated hemoglobin and pulse rate non-invasively. The absorption of selected
wavelengths of light is measured with sensors. Although these parameters process
the MSpO
2
measurements differently, the function and appearance of MSpO
2
on
your monitor is the same.
No Implied License
Possession or purchase of this device does not convey any express or implied license
to use the device with unauthorized replacement parts which would, alone, or in
combination with this device, fall within the scope of one or more of the patents
relating to this device.
Sensors
Before use, carefully read the manufacturer’s sensor directions for use.
CAUTIONS
TISSUE DAMAGE—Tissue damage can be caused by incorrect
application or use of a MSpO
2
sensor, for example by wrapping
the sensor too tightly. Inspect the sensor site as directed in the
sensor’s directions for use to ensure skin integrity and correct
positioning and adhesion of the sensor.
Do not use damaged sensors.
Do not use a sensor with exposed optical components.
Do not re-sterilize single-patient use sensors. For reusable sensors, refer
to the manufacturer’s instructions for cleaning and sterilization.
Do not immerse the patient cable in water, solvents, or cleaning solutions
(the patient cable connectors are not waterproof).
Do not re-sterilize the patient cable by irradiation, steam, or ethylene
oxide.
To Next Page
Loading...
Need help?
General
