To Next Page

To Previous Page

Revision C 250cx Series Maternal/Fetal Monitor 13-5

2036946-001

Heartbeat Coincidence: Using the Heartbeat Coincidence Feature

Strip Chart Annotation

When heartbeat coincidence detection is enabled, the annotation HBC prints in the

center margin of the strip chart paper following the active FHR modes. (Refer to

“Simulated Heartbeat Coincidence Detection Trace,” on page 13-5.)

As soon as heartbeat coincidence is detected, two overlaid hearts print in the

upper portion of the top grid of the strip chart paper; the hearts print every 4.5 cm for

as long a coincidence is detected. Once coincidence is resolved, two side-by-side

hearts print once.

If you disconnect a transducer while coincidence is detected, the overlaid hearts

stop printing. In addition, the mode status line prints on the strip chart paper—

without the

HBC annotation—indicating the deactivated mode.

Simulated Heartbeat Coincidence Detection Trace

Coincidence detected.

Coincidence resolved.

Coincidence enabled.

This annotation prints

every 30 minutes along

with the modes.

Simulated trends.

Other manuals for GE Corometrics 250cx Series

Questions and Answers:

Need help?

Do you have a question about the GE Corometrics 250cx Series and is the answer not in the manual?

General