Revision C 250cx Series Maternal/Fetal Monitor 11-5
2036946-001
Recorder Modes: Functionality with a QS System
CAUTION
DATA STORAGE—Stored maternal vital signs history data is
erased when you turn the monitor off. Therefore, for intermittent
monitoring, it is recommended that you leave the monitor on, but
turn the recorder off. Refer to Chapter 12, “Maternal Vital Signs
History” for more information.
Functionality with a QS System
Users of a Quantitative Sentinel (QS) System (Software Version 4.0.3.0 or earlier)
should be aware of the following items when using the monitor’s maternal-only
mode:
Paper Versus Electronic Strip Charts
As described earlier, the monitor’s maternal-only mode acts as a “paper saver”
turning the strip chart recorder on and off as needed. However, the QS System
overrides the maternal-only mode by storing the entire patient record. In other
words, the electronic strip chart is retained as if the monitor’s recorder were left on
Changing Recorder Modes
From To Button
Off On Briefly press once; or press and hold 3 seconds.
Off Maternal-Only Briefly press twice.
On Maternal-Only Briefly press once.
On Off
Press and hold 3 seconds.
1
Maternal-Only On Briefly press once.
Maternal-Only Off
Press and hold 3 seconds.
1
1
A confirmation tone sounds to indicate the recorder has been turned off.
Recorder Mode Audiovisual Indicator Status
Recorder Mode Record Indicator Audio Indicator
On continuously illuminated
Off
Maternal-Only lights three short flashes every
5 seconds
Off Off
To Next Page
Loading...
Need help?
General
