Revision C 250cx Series Maternal/Fetal Monitor 15-3
2036946-001
Maintenance: Cleaning
Cleaning
General care and cleaning are required for the 250cx Series Monitor and its
accessories. If an accessory is not listed, consult the manufacturer’s instructions.
CAUTION
Unplug the monitor from the AC power source and detach all
accessories from the monitor. Do not immerse accessories in any
liquid. Do not use abrasive cloth or cleaners on monitor or
accessories.
Monitor Exterior
1. The exterior surfaces of the equipment may be cleaned with a dampened, lint-
free cloth. Use one of the following approved solutions:
Commercial diluted bleach solution
Mild soap (diluted)
Commercial diluted ammonia solution
NOTE: Always dilute cleaning solutions per manufacturers’
recommendations.
2. Wipe off cleaning solutions with a clean dry cloth.
3. Do not use a cleaning substance containing wax.
4. Do not pour or spray water or any cleaning solution on the equipment or permit
fluids to run behind switches, into the connectors, into the recorder, or into any
ventilation openings in the equipment.
5. Do not use the following cleaning agents:
Abrasive cleaners or solvents of any kind
Acetone
Ketone
Alcohol-based cleaning agents or
Betadine
CAUTION
Failure to follow these rules may melt, distort, or dull the finish of
the case, blur lettering on the labels, or cause equipment failures.
Cleaning products known to cause the types of problems
mentioned above include, but are not limited to Sani-Cloth
Wipes*, Sani-Wipes*, and Ascepti Wipes*. These should be
avoided. Products containing active ingredients and solutions
similar to these products should also be avoided.
To Next Page
Loading...
Need help?
General
