8 HYDRAN 201CI-C INSTALLATION
Please read the following Sections before proceeding with the installation:
• General warnings, in Section 6.1.
• Installation overview, in Section 6.2.
8.1 Incoming Inspection and Verification
It is strongly recommended that you verify the operation of the Hydran 201Tis and
Hydran 201Ci Controllers before their installation. This verification also confirms that no
damage occurred during shipping and allows the user to become familiar with the
Hydran 201i System. The Hydran 201Ci-C installation procedure is described in Section
8.3.
8.1.1 Receiving and Unpacking
Upon receipt, the shipping box contains one pre-assembled Hydran 201Ci-C.
1. Open the shipping box.
2. Remove the Test Certificate and Data Sheet (for an example, see Figure 7-1).
3. Carefully remove the H201Ci-C from the box.
Note: Keep the packing material for storage or further shipment of the H201Ci-C.
8.1.2 Inspecting
Verify the Hydran 201Ci-C completely as outlined below.
1. Inspect the enclosure for any visual damage (bump, scratch or others).
2. Open the enclosure door using a flat-blade screwdriver.
3. Verify the AC power supply voltage (indicated on the label inside the H201Ci-C,
near the power supply terminal block) corresponds to the power source voltage
and the value on the Test Certificate and Data Sheet (for an example, see Figure
7-1). There are two possibilities:
• 115 V, corresponding to 100–120 VAC 50/60 Hz
• 230 V, corresponding to 200–240 VAC 50/60 Hz
4. Ensure the H201Ci-C’s serial number (indicated on the right internal side of the
enclosure wall or on the back of the door) corresponds to those indicated on the
Test Certificate and Data Sheet and on the shipping box.
5. Report any discrepancy to the company supervisor and the General Electric
Customer Service (contact information can be found at the bottom of page 2).
Note: Never return equipment without first contacting the General Electric Customer
Service.
To Next Page
Loading...
