11.5.3 Fail Alarm Cancellation
Note: To be cancelled, an alarm condition must disappear during a period of time
exceeding the corresponding alarm delay (if existing for this condition).
To cancel a fail alarm, proceed as follows:
1. Find and solve the problem (for help, see Section 11.5.2).
2. Acknowledge the alarm using the Hydran 201Ti’s keypad or the Hydran Host
software. For the procedure, see Section 5.2.1, and the Hydran Host Software
Manual. If the problem has been corrected during a period of time exceeding the
corresponding alarm delay, the alarm message then disappears from the
H201Ti’s display; otherwise, it simply stops flashing and remains on the display.
To Next Page
Loading...
