Hydran* 201i Instruction Manual
MA-033 Rev. 14.0, 12-Nov-18
Figure 10-4: Host Computer Connection Modes in a Hydran 201 Ti RS-485 network
A Hayes-compatible modem can be pre-installed and pre-set at the factory in an
H201Ci. For details on settings, refer to the modem procedure located in the
English/Procedures folder of the Hydran 201i System installation CD. A typical
communication configuration with a modem is shown in Figure 10-5.
The modems supplied by General Electric should be connected
to an analog line only. Using a non-analog line (for example,
digital, PBX, Multi-line) will damage the modem.
To Next Page
Loading...
