EasyManua.ls Logo

GE Hydran 201i - Page 234

GE Hydran 201i
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MA-033 Rev. 14.0, 12-Nov-18
Hydran* 201i Instruction Manual
Page 234
Set-up Lost ON Setup lost alarm turned on
Soft WatchDog Reset of Hydran 201Ti induced by the software watchdog
Sp Span chg Modification of the sensor temperature set point’s range
STempAlr Ack Sensor temperature fail alarm has been acknowledged
STempAlr H chg Modification of the sensor temperature High alarm’s set point
STempAlr H ON Sensor temperature High alarm turned on
STempAlr HH chg Modification of the sensor temperature High-High alarm’s set
point
STempAlr HH ON Sensor temperature High-High alarm turned on
STempAlr L chg Modification of the sensor temperature Low alarm’s set point
STempAlr L ON Sensor temperature Low alarm turned on
STempAlr LL chg Modification of the sensor temperature Low-Low alarm’s set point
STempAlr LL ON Sensor temperature Low-Low alarm turned on
STempDelay chg Modification of the sensor temperature alarm’s delay
STemp H OFF Sensor temperature High alarm turned off
STemp HH OFF Sensor temperature High-High alarm turned off
STemp L OFF Sensor temperature Low alarm turned off
STemp LL OFF Sensor temperature Low-Low alarm turned off
STempSetP chg Modification of the sensor temperature set point
SystemCalib Calibration of Hydran 201Ti
TDM Mode chg Modification of the TDM signal’s operating mode
Unit in Service Hydran 201Ti back in service after the battery was disconnected
Watchdog Reset of Hydran 201Ti induced by the hardware watchdog

Table of Contents

Other manuals for GE Hydran 201i

Related product manuals