GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
8-20 Section 8-2 - Software Loading Procedures for BT09 (R8.x.x or later)
8-2-8-3 Hardware Device Check: (cont’d)
4.) If X or ! is displayed:
- Left-click on the device with x mark, then rigtht-click on Enable.
- Left-click on the device with ! mark, then rigtht-click on Properties to perform the device driver
reconfiguration. When some files are required, designate the file in the directories of
C:\WINDOWS\SYSTEM32 or C:\WINDOWS\SYSTEM32\DRIVERS. If they are not found,
search them using a windows search function.
5.) Close the window.
To Next Page
Loading...
