GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
Section 8-2 - Software Loading Procedures for BT09 (R8.x.x or later) 8-47
8-2-10-7 Regional Setup (For the system with language other than English ONLY) (cont’d)
2.) Select the Advanced tab, then select the language in the Language for non-Unicode programs pull-
down menu. Press Apply. Answer Yes to use files already loaded on the hard disk, then answer
No to not reboot the system yet, press OK. Press Save and Exit the Utility screen.
3.) Reboot the system. When your system restarts, the system appears in the selected language.
4.) To type foreign characters, press Alt+Shift to change the keyboard to the international keyboard,
then press and hold down the Alt GR+appropriate keyboard key.
Figure 8-109 Advanced tab
To Next Page
Loading...
Need help?
General
