Chapter 5: Quick Steps
5495975-1EN Rev.9 5-2
© 2013-2017 General Electric Company. All rights reserved.
WARNING Before your patient gets on or off the digital table, always press the Table Lock
Control button to block the foot pedal functions momentarily. This avoids injuries
to the patient or damage to the equipment if a foot pedal is accidentally stepped
on.
Figure 5-1 inhibition warning label
Position the Table Longitudinally and Transversely
1. Release the table lock, if necessary.
2. Press the table top positioning foot pedal two consecutive times (“double-tap”). This activates the foot
pedal.
3. Hold the foot pedal down and position the table top.
You can float the table top in all directions while the pedal remains held down.
4. Manually move the tabletop in a longitudinal or transverse direction to the desired position.
5. Release the foot pedal to lock the tabletop.
WARNING When moving the tabletop, be careful of where your and the patient’s fingers are
placed. Do not attempt to move the tabletop without using the foot pedals to
release the longitudinal and transverse movement locks.
WARNING To avoid injury to fingers and hand of patient and operator caused by table move-
ment, hands must be kept away from table top edges at all times.
To Next Page
Loading...
