Chapter 9: Worklist
5495975-1EN Rev.9 9-10
© 2013-2017 General Electric Company. All rights reserved.
If no procedures met all the criteria, the Worklist will be blank.
8. Click [REFRESH] to remove the filter.
Refresh
The system may be configured to automatically refresh the Worklist with data from the HIS/RIS on a reg-
ular basis (such as every 10 minutes). However, if your system does not automatically refresh—or you
want to refresh the list before the scheduled time—you are able to refresh the list manually.
The Refresh feature also removes any filtering that has been applied. Refer to Filter List
(p. 9-7) for more
information.
Manual Refresh
Follow this process to manually refresh the Worklist.
9. Click [REFRESH] on the Worklist.
The Worklist updates with HIS/RIS data and removes any filtering.
Note: Refresh does not remove locally added procedures.
Note: You will not be able to make selections or access Worklist functions while the Worklist is refresh-
ing.
Auto Refresh
The Auto Refresh interval is set on the Preferences – Worklist screen in System Utilities. Refer to
Chapter 15: Preferences
-Worklist (p. 15-17) for more information.
When the system auto refreshes, a message (Figure 9-7) appears: “Auto Refresh in progress. Please wait.”
The message remains until the refresh process is complete.
Note: You will not be able to make selections or access Worklist functions while the Worklist is refresh-
ing.
Figure 9-7 Auto refresh message
To Next Page
Loading...
