Chapter 2: Safety and Regulatory
5495975-1EN Rev.9 2-27
© 2013-2017 General Electric Company. All rights reserved.
X-ray Tube Operational Symbols
Table 2-10 describes the operational symbols for the system such as X-ray emissions and col-
limator locations.
Gost Mark.
This mark indicates that the Device is confirmed according Russian standards.
The symbol indicates the instruction for use of Lateral positioning bar.
Table 2-9 Special notices
Symbol Description
Table 2-10 Operational symbols
Symbol Description
X-ray emission is used to indicate the X-ray tube head is emitting X-rays. Take
adequate precautions to prevent the possibility of any persons carelessly, unwisely,
or unknowingly exposing themselves or others to radiation.
X-ray source assembly is used to indicate a reference to an X-ray source assembly.
X-ray tube is used to indicate a reference to the X-ray tube, e.g., to mark the surface
of a grid, which is to be oriented towards the X-ray tube.
Identifies controls or indicators associated with normal rotational speed of the X-ray
anode.
Identifies controls or indicators associated with high rotational speed of the X-ray
anode.
To Next Page
Loading...
