GE Optima XR646 - Re-Process Images

Chapter 13: Advanced Applications
5495975-1EN Rev.9 13-27
© 2013-2017 General Electric Company. All rights reserved.
Figure 13-28 Exam/Series panel
Re-Process Images
The Image Processing tab of the Image Tools panel (Figure 13-29) contains the tools to re-process and
repaste sub-images and pasted images.
Refer to Change Looks Processing (Vertical Equalization)
(p. 13-30) for more information.
Figure 13-29 Image Tools panel – Image Processing tab
Re-paste
Re-pasting allows you to manually correct the alignment of the sub-images and create a new composite
image.
Re-paste is used in the following situations:
 If the exposure was ended before all acquisitions were taken (therefore the system could not process
the sub-images into a pasted composite image).
 If the pasted composite image is not properly aligned.
The Re-pasting screen (Figure 13-31) is accessed by clicking the [REPASTE] button (Figure 13-30) on the
Image Tools - Image Processing tab.